Coil silicon steel sheet igniter: high power, high energy, high spark temperature, ignition time of about 10 minutes, otherwise it will burn out due to heat, small and light.

Electronic high-frequency high-voltage igniter: high power, high ignition energy and high spark temperature, but the ignition time is generally not more than 5 minutes, otherwise it is easy to heat up and burn out, and the volume is large and heavy, and the device is difficult to transport.

Electronic pulse ignition controller: The pulse type has low ignition energy due to low power, and the generated spark temperature is low. For the mixed gas with high selectable local ignition point and low concentration, the blower extinguisher is ignited. The ignition rate is low, and safety accidents such as ignition failure or deflagration often occur. Long-term and continuous ignition is easy to burn out the fuel extinguisher.





The detailed steps for using the automatic ceramic ignition needle are as follows:
1. Fix the igniter on the workbench and install the striker;

2. Connect to oxygen and acetylene, the straight-through pagoda joint is the air inlet, and the curved pagoda joint is the air outlet, please install it accordingly;

3. Adjust the position where the welding gun is placed, according to personal habits, adjust the position of the proximity switch, 2 to 6 mm from the welding gun rod;

4. Turn on the 220V power supply, turn on the power switch, and the working indicator light is on;

5. Lift the welding gun, the igniter starts to work, turn on the gas source to ignite and adjust the flame, put the gun to turn off the flame, lift the gun to ignite, pay attention to the torch head when igniting, please approach the igniter, and you can start to work normally after repeated proficiency;

6. If the device is not used for a long time, please turn off the power switch.